Thingiverse
Wolfwhoop wt02 Mount
6
Download
3
Likes
0
Makes
Little flat mount for the Wolfwhoop WT02 camera. Flat mount.
Two ways you can make it work:
1: Print it at 102-103 percent
-or-
2: Print it at 100 percent, carefully JAM IT IN (it's really tight)
then run the camera for about 20 minutes.
The camera gets hot, the plastic softens a bit, and then it fits perfect!
Be careful if you choose the second method as you may ruin the camera by breaking off the delicate surface mount parts.
Two ways you can make it work:
1: Print it at 102-103 percent
-or-
2: Print it at 100 percent, carefully JAM IT IN (it's really tight)
then run the camera for about 20 minutes.
The camera gets hot, the plastic softens a bit, and then it fits perfect!
Be careful if you choose the second method as you may ruin the camera by breaking off the delicate surface mount parts.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
