Thingiverse
Wondom BRB3 Bluetooth receiver case
von p4nd4x
0
Downloads
1
Likes
0
Makes
Complete case for the Wondom BRB3 ( AA-AB41136 ) APT-X Bluetooth Ver4.0.
Dimensions may vary, as the board i have received doesn't match the pictures found online .. ? The ref does, but not the pictures.
Anyway, parts are a bit loose, i did it quickly without any caliper.
I'd avdice gluing the board on the little slots, with hot glue or silicone.
Same for the cover, too lose, doesn't hold in place, i'd use a bit of glue to hold it in place.
(The box isn't meant to be seen, hence the lack of finish. It's just to avoid the green light flashing my entire room for nothing ...)
Dimensions may vary, as the board i have received doesn't match the pictures found online .. ? The ref does, but not the pictures.
Anyway, parts are a bit loose, i did it quickly without any caliper.
I'd avdice gluing the board on the little slots, with hot glue or silicone.
Same for the cover, too lose, doesn't hold in place, i'd use a bit of glue to hold it in place.
(The box isn't meant to be seen, hence the lack of finish. It's just to avoid the green light flashing my entire room for nothing ...)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!