Woozi Folding stock

Loved the addition of the stock attachment point, but I REALLY wanted a folding stock that was sleek, and somewhat resembled an actual micro UZI stock, so I found a 1:1 mini uzi replica here on Thingiverse and tweaked it (a lot), and created a mounting plate.

parts are generally oriented for printing. use supports where appropriate

I recommend a bit of a brim for printing the arm

*you will need a build height of at least 234mm to print the arm in one piece*

I have found that driving a screw through the hinge plate into the hinge pin from below helps stability

the hinge contact surfaces will need a little sanding to fit properly, and the ends of the arm need to be sanded to fit in the butt plate holes. it will be snug, and no glue is necessary.

**The hinge needs to be printed at high infill. I recommend 100% **

**Issue found in slicing butt plate on cura 4.1 not present on earlier versions. if using 4.1 check the keep disconnected faces setting in mesh fixes**