Thingiverse
Work glove holder - Peg Board
by Scottj21
108
Downloads
60
Likes
0
Makes
I found useful pegboard holders but wanted something for my work gloves... and something that didn't waste too much material.
The inside slot is 10.5 x 2 in wide which gives enough room to comfortably fit gloves etc.
Pegs are 6 mm so they should press fit into 1/4" board (depending on how accurate your printer is and if it has elephants foot etc.
The inside slot is 10.5 x 2 in wide which gives enough room to comfortably fit gloves etc.
Pegs are 6 mm so they should press fit into 1/4" board (depending on how accurate your printer is and if it has elephants foot etc.
Scottj21 also publishes on
16 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
