Thingiverse
Work Sharp Precision Adjust PSA Lapping Film Adapter
door PerodisCS
168
Downloads
101
Likes
0
Makes
This is an accessory for the Work Sharp Precision Adjust knife sharpening system so you can use PSA lapping films to get a mirror finish on your knives. This would replace the normal 3 sided grind stone and you adhere your lapping films, or any other preferred sharpening media to the plates.
These are the lapping films that I use as they are the same length as the plates so you only need to cut them once:
https://www.amazon.com/3M-TM-Microfinishing-Sharpening-Aluminum/dp/B07TDMS1H8/ref=sr_1_2?dchild=1&keywords=psa+lapping+film&qid=1631742872&sr=8-2
For each sharpener body, print 3 film plates and adhere them to the body with super glue. I find that the side that was on the print bed is smoother so make sure that side faces out when gluing them in place.
Printing:
- Sharpener Body:
Align the body of the sharpener vertically, 20% infill seemed plenty sturdy. I printed with
and without a raft and had no problems with it coming off the print bed.
- Plates:
Pr
These are the lapping films that I use as they are the same length as the plates so you only need to cut them once:
https://www.amazon.com/3M-TM-Microfinishing-Sharpening-Aluminum/dp/B07TDMS1H8/ref=sr_1_2?dchild=1&keywords=psa+lapping+film&qid=1631742872&sr=8-2
For each sharpener body, print 3 film plates and adhere them to the body with super glue. I find that the side that was on the print bed is smoother so make sure that side faces out when gluing them in place.
Printing:
- Sharpener Body:
Align the body of the sharpener vertically, 20% infill seemed plenty sturdy. I printed with
and without a raft and had no problems with it coming off the print bed.
- Plates:
Pr
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
