Thingiverse
Workpiece Clamps
by jack0088
3
Downloads
6
Likes
0
Makes
Print the handle once.
Print at least two or more pairs of the pivot + wedge.
Print at least three or more edge support pins.
Stick the pivot into the wedge. Plug the pivot then into a workbench hole (my workbench has 20mm holes in diameter, at a matrix of 96x96mm) and use the handle to tighten or loose the clamp to fixate your workpiece in place.
Print at least two or more pairs of the pivot + wedge.
Print at least three or more edge support pins.
Stick the pivot into the wedge. Plug the pivot then into a workbench hole (my workbench has 20mm holes in diameter, at a matrix of 96x96mm) and use the handle to tighten or loose the clamp to fixate your workpiece in place.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
