Workshop Pencil Holder Wall Mount

Why, hello there!

Say hello to my little friend. This charming little fellow is my workshop pencil/pen holder. It holds 18 devices, the cradle cylinders are 70mm (just under 3") and 15mm (about 5/8") wide. They will hold marker- and pen-type sharpies, as well as carpenter pencils and the like.

It can be wall-mounted and sticks off at a 20 degree angle , more or less, from dead-level. It can also be mounted vertically and it'd be 20 degrees off of dead vertical.

I printed it with the "back plate" flat to the bed, with 3 walls, 3 layers top and bottom, 4% gyroid infill, combination infill layers, 0.32 layer height and 0.3 first layer, on my Kobra Neo. It took 8hr50 to print, and cost 120g of filament.

It's a lovely gadget that keeps my favorite writing utensils close at hand. No fumbling for shit, no rooting through bins or bottles, and I always know when one is missing. I keep my mechanical carpenters pencils on the first row, carpenter pencil lead refills on the next one up