Thingiverse
Engineering
Go to Model
worm gear involute
13
Downloads
17
Likes
0
Makes
My attempt to make a worm
module 1, reduction 1/36
30 ° pressure angle to facilitate printing (normal 14.5-25 °)
the screw require you can print with overhand 30 °
the screw printed very slow 15mm/s, layer 0.1mm
the gear 30mm/s, layer 0.1mm
the rest layer 0.2mm
require:
screw 2 x 8mm
shaft 2mm
drill 2mm and 2.1mm
note: solidworks source files available
module 1, reduction 1/36
30 ° pressure angle to facilitate printing (normal 14.5-25 °)
the screw require you can print with overhand 30 °
the screw printed very slow 15mm/s, layer 0.1mm
the gear 30mm/s, layer 0.1mm
the rest layer 0.2mm
require:
screw 2 x 8mm
shaft 2mm
drill 2mm and 2.1mm
note: solidworks source files available
buho29 also publishes on
30 additional models across 3 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
