Wormhole Chess Board by DaveMakesStuff

For assembly, the primary profile uses 1/8" diameter cylindrical magnets. The thickness can be 1/16" or greater. I have also uploaded one resized for 3mm magnets as well as some profiles for smaller layer heights for the curved squares. I printed the 1/8" and glued in 3mm magnets, and glue may be required either way. My 3mm magnets did not stick automatically in the 3mm chess pieces, so at least the chess pieces require glue. The main instruction necessary for building is that the inner pieces have small dots that point to the pentagon piece. On my first build, I personally experienced difficulty fitting the final inner pieces in each of the two inner layers, having to press very hard to snap it in, but I think this can be avoided if you make sure that all pieces are snug together. (I recommend placing the pieces: 1-2-3-4-1-2-3-4-1-2-3-4-1-2-3-4, I placed them as 1-1-1-1-2-2-2-2-3-3-3-3… and then had to press very had to squish in some of the final 4 pieces). My other recom