worx landroid rain sensor repair (+ tutorial)

So, your landroid rain sensor stay always on
(you dont even need to print this part if you don't broke the other one)

On my model (WR165E) there is a plastic cover under the landroid that you can remove whiteout any tool and then remove the sensor by pushing if from this side.
I did not wanted to fully disassemble the mower so I cut the wire to work on the sensor.

-Use a small blade to remove the rubber from the side of the housing and gently hammer the pin.
-With the small blade remove the rubber from the wire, don't pull too hard on the wire or it will pop out of the sensor pin.
-use adhesive lined heat shrink tube to protect the end of the sensor pin (you can extend the wire too)
Put it back in the sensor housing and put sealant in the hole to fix it in place.

here you saved 50 euros.