Thingiverse
Wowgo Bumper
von Preid
0
Downloads
2
Likes
0
Makes
Slap one of these on each end of your board to save the wood splitting through all those impacts.
Print in PETG or TPU ideally although PLA might last a few bumps. Attach to the board using hot glue.
Works great.
Print in PETG or TPU ideally although PLA might last a few bumps. Attach to the board using hot glue.
Works great.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!