Wowgo - Bushings

Designed for use on Wowgo2s esk8 board ,but should fit a lot of boards ,
since the bushing is a standard.

For one set you need to print both the "cone" and the "straight" one .
I used NinjaFlex as filament but you can use any soft or hard flex filament.
I think that the NinjaFlex i used have a shore softness/hardness around a85 .
I did print these with 100% infill ,but you can play around with the infill settings
to adjust it to your taste in how dampening they should be .

Designed for use on Wowgo2s esk8 board ,do not know if it fits any other boards .

For one set/end you need to print 2 pcs. of this and glue it to the board ,i used some
strong glue and had it sit for some time ,works perfectly :-) .
I used NinjaFlex as filament but you can use any soft flex filament.
I think that the NinjaFlex i used have a shore softness/hardness around a85 .
This is v1 which i use atm ,but i have designed and printed a v2 of this
fender that is in one piece ,it looks nicer th