Wowgo - Rubber Handle

Designed for the handle on Wowgo2s esk8 board ,do not know if it fits any other boards .

If you found this design very helpful or otherwise wish to support me ,you can buy me a cup of coffee ( helps keeping the brain active so i can create new stuff ) ;-) ,then please
consider using this link :


The original rubber handle was not very good on my new board ,started
falling of soon after i got the board ,so i decided to make my own .
You need to print 2 pcs. of this and glue it to the board ,i used some
strong glue and had it sit for some time ,works perfectly :-) .
I used NinjaFlex as filament but you can use any flex filament ,just be sure
that it is very soft otherwise it will not be pleasant to grab on to .
I think that the NinjaFlex i used have a shore softness/hardness around a85 .

Designed for use on Wowgo2s esk8 board ,do not know if it fits any other boards .

For one set/end you need to print 2 pcs. of this and glue it to the board ,i used some
strong glu