Wowstick Flat Case

A Wowstick 1F+ holder, with space for 40 bits.
(A bit wider than the original case, but also flatter and less-long.)

Uses four 4x2mm disc magnets to hold the halves together.


Printed with 0.2 layer height.

- Screwdriver fit is proper, though test with was with an earlier iteration.
- Hexbits fit is a little tight, but loosens with a few insertions.



Will update this from WIP to real (with pictures) once I'm done tinkering:

- Do fingers fit to pull bits out? (Need to lengthen the case?
- Magnet fit and strength? (Need stronger/bigger magnets?)
- Screwdriver fit w/ halves? (Increase height tolerance?)
- Print-in-Place Hinge? (How annoying are bits?)


2021-07-09 -- Added a different variant (wsr_*) that uses a removable bit holder. This should allow for easier manipulation of the bits, and also makes the case even smaller. [Not Yet Printed; above testing list still applies...]