Thingiverse
Wrench Hanger
by volarne
0
Downloads
0
Likes
0
Makes
Very basic but tough hanger for 3/4 wrench / crescent wrench - made it to be double sided taped to the side of our Slitter in the shop, to hang our table adjuster wrenches from.
Print it with no supports at 25% infil (I used gyroid for toughness) or more to really firm it up. I used PLA for simplicity, and because I know that it will be tough enough - if you are worried, switch out to PETG, but shouldn't be necessary.
Print it with no supports at 25% infil (I used gyroid for toughness) or more to really firm it up. I used PLA for simplicity, and because I know that it will be tough enough - if you are worried, switch out to PETG, but shouldn't be necessary.
volarne also publishes on
13 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
