Thingiverse
Wrist lap counter
door haakemon
9
Downloads
8
Likes
0
Makes
I'm moving all my files to printables.com. This model is now available here: https://www.printables.com/model/849-lap-counter
The base has been remixed to be able to attach a standard 20mm watch strap to it.
The top has been remixed to fill the hole, because I did not like the look of it when you could see the base. This should be printed in *150 microns or less* to get a nice top layer (the fill layer is very thin)
My girlfriend swims a lot, and also listens to audiobooks while swimming - and it is difficult to keep track of how many laps you swim while listening to audiobook at the same time, so I figured this might be a simple and cheap solution.
To print this, you also need to print the springs (2x) and the counter wheels (1x large, 1x small) from the original project. I would suggest using the v2 versions.
(it has not been water tested yet :) )
The base has been remixed to be able to attach a standard 20mm watch strap to it.
The top has been remixed to fill the hole, because I did not like the look of it when you could see the base. This should be printed in *150 microns or less* to get a nice top layer (the fill layer is very thin)
My girlfriend swims a lot, and also listens to audiobooks while swimming - and it is difficult to keep track of how many laps you swim while listening to audiobook at the same time, so I figured this might be a simple and cheap solution.
To print this, you also need to print the springs (2x) and the counter wheels (1x large, 1x small) from the original project. I would suggest using the v2 versions.
(it has not been water tested yet :) )
haakemon publiceert ook op
18 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
