Wrist rest

For everyone who does not have a printer bed large enough for a unibody print:
Feel free to remix and adjust widths and sizes as needed. It is currently sized for 60% to comfortably use with something like a Tofu60. The added feet give it about 4mm extra height for taller boards like the Viktus Sinne, Salvation, etc.
I believe the current tolerance/offset I used for these pieces are 0.1mm--but please adjust as needed for your filament/printer!

These are updated files to use with magnets superglued into the pieces. Without magnets, they will fit fine but if you disassemble and reassemble a lot, the pieces will become loose and annoying. Make sure you glue in the magnets with the correct polarity so pieces pull towards each other!
I also included a stand you can print to hold the feet.

Please cut strips of silicone padding to 1inchx4mm for the feet and bumpers.

Print upside down so the top face of the wrist rest is smooth (or textured) from your printer bed!

Products used:
Small 3