Thingiverse
Automotive
Zum Modell
WRX Lock Badge
23
Downloads
49
Likes
0
Makes
This model will fit a 02-07 Subaru Impreza (WRX,STi) Trunk lock hole.
This badge inserts at a 45 deg and locks into place.
*Mine was printed in PLA and it started to warp over time in the elements (6 Months or so)
Overall dimensions should be 29mm x 85mm x 12mm (Check scaling)
Like and comment if you would like to see more! Thanks!
This badge inserts at a 45 deg and locks into place.
*Mine was printed in PLA and it started to warp over time in the elements (6 Months or so)
Overall dimensions should be 29mm x 85mm x 12mm (Check scaling)
Like and comment if you would like to see more! Thanks!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
