Thingiverse
WRX VB (2022+) Trunk Handle
door NoonOnFridayDesigns
1
Downloads
6
Likes
1
Makes
Original model didn't fit on 2022+ WRX models even though the latch mechanism is very similar, I had to resize the “legs” of the handle to fit into the narrower hole on the 2022+ WRX.
Non-printed parts necessary:
2 - M6-1.0 x 20mm screws (Hex socket type recommended)
2 - 6mm washers
Non-printed parts necessary:
2 - M6-1.0 x 20mm screws (Hex socket type recommended)
2 - 6mm washers
NoonOnFridayDesigns publiceert ook op
13 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
