Thingiverse
WS-0802 Temp Probe Holder
door ChuckMcM
3
Downloads
1
Likes
0
Makes
We use an [Ambient Weather WS-802](https://www.ambientweather.com/amws0802.html) indoor/outdoor thermometer when we are camping to monitor indoor and outdoor temperatures.
The previous one we owned (a different model, same company) came with a small stand for the remote transmitter which was very handy. This one however did not, so I set out to correct that oversight by printing one!
This is a very simple print and not very challenging for any printer. It is slightly "oversize" for the sensor to allow for variations. Using some Velcro tape on the bottom of the sensor and on the stand will make sure they stay together even if they fall off the place where you put them.
The stand is small enough that it packs easily in the box with the base station and the temperature remote.
The previous one we owned (a different model, same company) came with a small stand for the remote transmitter which was very handy. This one however did not, so I set out to correct that oversight by printing one!
This is a very simple print and not very challenging for any printer. It is slightly "oversize" for the sensor to allow for variations. Using some Velcro tape on the bottom of the sensor and on the stand will make sure they stay together even if they fall off the place where you put them.
The stand is small enough that it packs easily in the box with the base station and the temperature remote.
ChuckMcM publiceert ook op
23 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
