WS2811 seed pixel black cat

This is a seed remix of jobu109's WS2811 Black Cat. The seed holders work best if you push the seeds in from the back. I found that leading with a small bit of wire and then passing the seed through makes it go in easier. once through, flatten and press in.

I flattened the entire model to 5mm before adding the seed holders. this is a work in progress and I'm still printing out the first one so if I run into any issues with this thickness I'll adjust and post an update here.

The xmodel can be obtained from the original file here: https://www.thingiverse.com/thing:6560381

I'm also working on a version with eyes and will upload the file and xmodel (with submodels) here once's it's complete.

UPDATE: After printing our the original design I found that the spacing up and down the tail was too far to alternate seeds up and back down so I modified pieces 7 and 8 to increase the density.

I also uploaded the head piece that I modified to have eyes. Also included is