Thingiverse
WT32-ETH01 Case with SnapLip
32
Downloads
24
Likes
1
Makes
A simple snap-fit Case for the WT32-ETH01 Board. Pinout to the upper side for Jumper-Cables, but is flat with the lip. The Ethernet Connector sticks out on the upper side.
Print with PETG or ABS due to the heat from the esp32!
Print with PETG or ABS due to the heat from the esp32!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!