Thingiverse
Wuben E7 Lamp Cap Bracket
door Lancastreen
1
Downloads
1
Likes
0
Makes
Bracket made of PLA, the design has a fix 10 deg angle pointing down .
PLA works fine, print it in the shown orientation to get the right proper of the clip.
The design has 4x Magnets of 6mm diameter x 1.7mm height but the design is tight enough to slide and don't depend on the magnets to keep attached.
I might work on a variable angle mechanism in the future
PLA works fine, print it in the shown orientation to get the right proper of the clip.
The design has 4x Magnets of 6mm diameter x 1.7mm height but the design is tight enough to slide and don't depend on the magnets to keep attached.
I might work on a variable angle mechanism in the future
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
