Thingiverse
X-ACTO Case #2
von KWolfie
5
Downloads
13
Likes
0
Makes
Made this to store my X-Acto #2 handle and my extra blades. I'm not sure exactly how many blades it can hold. but I'm guessing about 50.
Requires two magnets, dimensions are 8x2mm. I used a small dot of hot glue in the holes of the print to glue the magnets in. Havent had any trouble with this.
Oh, and getting the blades out can be tricky. I either use the magnet on the lid to pull them up or I use the tip of a blade to fish them out. Or if all else fails just dump them out. Just don't use your fingers.
Requires two magnets, dimensions are 8x2mm. I used a small dot of hot glue in the holes of the print to glue the magnets in. Havent had any trouble with this.
Oh, and getting the blades out can be tricky. I either use the magnet on the lid to pull them up or I use the tip of a blade to fish them out. Or if all else fails just dump them out. Just don't use your fingers.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
