Thingiverse
x axis cable holder
von digitalcarnage
307
Downloads
185
Likes
3
Makes
Made for my Anet A8 but should work for any printer
this is printed with a support for the 3.5 mm hole for a screw.
only 1 MM thick so it is flexible with PLA.
Prints in 5 min or less.
this is printed with a support for the 3.5 mm hole for a screw.
only 1 MM thick so it is flexible with PLA.
Prints in 5 min or less.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
