Thingiverse
X Axis holders
von Tuim
35
Downloads
23
Likes
2
Makes
This is a remix of Jonaskuehlings Improved X Ends.
It is made for LM8UU, and 8mm smooth rods.
There is also a LM10UU version, but it still has 8mm holes for the X axis.
This remix will work very good with Richrap's quick fit extruder. http://www.thingiverse.com/thing:19590
The motor is placed 10mm further away from the threaded rod to align the X axis GT2 belt.
The opposite idler part is enhanced aswell. Although it was only made stronger no measurements have changed on this part
It is made for LM8UU, and 8mm smooth rods.
There is also a LM10UU version, but it still has 8mm holes for the X axis.
This remix will work very good with Richrap's quick fit extruder. http://www.thingiverse.com/thing:19590
The motor is placed 10mm further away from the threaded rod to align the X axis GT2 belt.
The opposite idler part is enhanced aswell. Although it was only made stronger no measurements have changed on this part
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
