X Box Kiosk Controller Holder

This is for an xbox kiosk that allowed you to test out the console and games before you bought it back in the early 2000's. This holds the controllers and was requested by someone off reddit because they couldn't find theirs. So I gave it a shot. I had never seen one of these before, but going off the pictures and some controller measurements, I think I found something pretty close to the original. The only part it doesn't have is the metal attachment. I need to do some more research into the measurements for that before I attempt it. Some notes: It prints in two pieces to allow the controller to be put in and you will need some screws and nuts to put it together. I will list those down below.If you are using the model that allows for the battery compartment, then you will need to kindof squeeze it into place. It's a tight fit. Then you place the top part on top and screw into place.You will need to put a pause in when you slice it, generally somewhere around layer 61,