X-Carve material clamp

This is made for 18mm wood (about only material that is readily available in Norway.) If you use material of another thickness either download the 123Design source file and modify the height of the back support accordingly or send me a message and I'll do it for you. The back support is slightly tilted to allow a firm grip on the material so it is essential that is made for the correct height material.

I've used the adjuster from http://www.thingiverse.com/thing:843070 to make it easy to tighten the screws holding the clamps down.

These are modeled after the hold down clamps https://www.thingiverse.com/thing:723173 but since I made them for a specific material thickness I could make these shorter. This enables me to use them in tighter spots than the ones mentioned above. Also, these are a lot lower, meaning they fit under my dust collector.