X-Lite Eachine FPV-Watch Magnet-Mount

I designed a Case for the FPV-Watch with a Built in Magnet.
Plus a Magnet Mount for the "X-Lite FPV-Watch Holder" from Hackbert (Taranis X-Lite Mod Kit). All Files needed are here.

Print the Case with Supports
Print the X-Lite Monitor Mount with Supports
Print the CaseHolder-Magnet without Supports


WARNINGS:

1. You have to cut away the Mounts for the Wristband to fit!

2. Be sure with the Orientation of the Magnets before putting them in!
If same Poles face each other, it wont work! Better check twice !!

3. You have to Pause the print, via Slicer, on the last Layer before the magnet-holes close to put the Magnets in! Then resume. This needs to be done for the CaseHolder-Magnet AND the Case.

4. For the Case, you have to disable Supports ONLY for the area where the Magnet has to be put in. Use Support-Blockers (in CURA) or similar in the slicer. You could also remove the supports just before you put the Magnet in. But a Support-Blocker saves Material, time and wo