Thingiverse
X-Lite Gimbal Stick End (threaded)
by agibson2
4
Downloads
7
Likes
0
Makes
I was looking for a longer gimbal stick end on thingiverse for the FrSky X-Lite Pro but I didn't find one that had threads to make it screw onto the gimbal. I decided to create one in Fusion 360 that does have theads on it.
In Cura, You might have to adjust 'Outer wall inset' to bring the walls in toward the inner wall to make sure the size is correct to compensate for outer wall overextrusion. I usually set mine to 0.16 when I need the object to have precise dimensions. It all depends on your printer though and how accurate your printer is setup to print.
The picture is of the 27mm version. I have settled on 22mm being the best for me.
2019-05-05
- Added 17mm and 22mm versions (previous version was 27mm)
- Tweaked the top design to be stronger
In Cura, You might have to adjust 'Outer wall inset' to bring the walls in toward the inner wall to make sure the size is correct to compensate for outer wall overextrusion. I usually set mine to 0.16 when I need the object to have precise dimensions. It all depends on your printer though and how accurate your printer is setup to print.
The picture is of the 27mm version. I have settled on 22mm being the best for me.
2019-05-05
- Added 17mm and 22mm versions (previous version was 27mm)
- Tweaked the top design to be stronger
agibson2 also publishes on
22 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
