X @nchor for Kobra X

When the printer is loaded with 4 spools with more than 50% remaining thread, the phenomenon of the front part being lifted is observed The phenomenon is MUCH MORE INTENSE in solutions where the spools are placed on the side or behind the printer frame, in which the center of gravity of the printer is shifted. This instability creates additional vibrations during printing, creating imperfections that affect the final result X @nchor solves this problem It ALWAYS keeps the printer stable in one position and eliminates the lifting phenomenon Working principle explained: The problem arises because the center of gravity is not exactly in the middle, in order to balance. This can be easily observed if you look at the printer, loaded with the filament spools, from the side. The weight of the filament rolls exerts a force towards the rear This divergent force lifts the front of the printer. When this force is directed upwards, with the intervention of X @nchor, an opposing force is simultaneously exerted downwards. One force neutralizes the other. In essence, X @nchor uses the same weight responsible for the problem, to its advantage It has been tested for over 110 hours This is the 3rd version Snug Fit on Purpose Modifications have been made to the geometry and infill of the object, after continuous use in the field The final refined result is an easy 90' print and 34 grams of material (for 2 pieces) It is recommended to use 4 pieces, in the positions shown in the pictures (front & rear side). Just slide in place, the thinnest part below the printer Huge improvement from 1st use. No assembly required. Just place X @nchor in possition Can be printed with all materials, tested with PLA, PETG & ASA Works PERFECTLY every time The 3mf file includes the best tested settings 24/05/2026 NOW LIVE ** VERSION 2 ** Structural modifications Elimination of the Horizontal lines phenomenon PETG recommended Best settings included in file