Thingiverse
X-One2 screen holder
door jef41
8
Downloads
6
Likes
0
Makes
I made this, then found another similar Thing at:
https://www.thingiverse.com/thing:2390608
I guess my version might print quicker. I designed this to hold the screen at a steeper angle, 60°, so it is a bit more horizontal than that other design.
Assembly is essentially the same as the other Thing.
Please disconnect from mains power before removing the base from the printer otherwise mains voltage live parts are accessible.
The brackets are a snug fit and require a little wiggle to locate, the fascia is simply a friction fit over the whole lot.
see also https://www.thingiverse.com/thing:2729170 in case you lost the 3.5" LCD screen cover.
https://www.thingiverse.com/thing:2390608
I guess my version might print quicker. I designed this to hold the screen at a steeper angle, 60°, so it is a bit more horizontal than that other design.
Assembly is essentially the same as the other Thing.
Please disconnect from mains power before removing the base from the printer otherwise mains voltage live parts are accessible.
The brackets are a snug fit and require a little wiggle to locate, the fascia is simply a friction fit over the whole lot.
see also https://www.thingiverse.com/thing:2729170 in case you lost the 3.5" LCD screen cover.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
