Thingiverse
X-Pro3 Handgrip
13
Downloads
14
Likes
0
Makes
After being asked, I did !
i'd say it's pretty good! I would suggest printing it at least 70% infill so it's stiffer.
I made the screw hole long and wide so there is room to fit it nicely.
I printed at prototype at 10% and it works but there is a lot of flex and curve maybe from when I released it from the print bed. Nonetheless it still work quite good.
i'd say it's pretty good! I would suggest printing it at least 70% infill so it's stiffer.
I made the screw hole long and wide so there is room to fit it nicely.
I printed at prototype at 10% and it works but there is a lot of flex and curve maybe from when I released it from the print bed. Nonetheless it still work quite good.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
