[X Tower] - Modular Rack for Kobra X

[X Tower] - Modular Rack for Kobra X 👇Find the file here 👇 Link: https://cults3d.com/:4548293 Hello 👋🏻  Here’s my take on the Ace 2 Pro top loader and spool relocation.  🏁GOAL:  -to have my Ace 2 Pro mounted on top of the Kobra X or my Ikea dry box -relocate the top spools to the side  -reduce stress or completely remove loads on the gantry (Z-axis) -make it height adjustable or modular -use the existing spool holder -no screws or hardware needed if possible -minimal footprint -room for upgrades  -easy to assemble  And of course, compatibility with my Modular Kobra X Riser 👍🏼 I have come up with this idea to build a modular rack at the rear of the printer while still having clearance on the print bed.  I made the top flat so I can put anything on it. Since it is not connected to the printer, I’m not bothered by any weight on top.  I also added a notch for the 22L box.  It is wide enough for the printer base but not too wide to increase footprint, it is almost the same width as the printer itself.  Spool holder is based on the original Kobra X spool holder, either use the stock holder or any printed spool holder of your liking.  There are 2 versions, the lower and middle. It is designed to be movable and can be removed if you prefer not to use it. It should fit snugly but adding a double sided tape on the area where it touches the rack should keep it in place.  Since it is completely detached, you can adjust how close or far you want it to be from the printer. Depending on your table or work area.  I designed it to be compatible with my other design, the Modular Kobra X Riser. Just add an extra 100mm and it should accommodate the extra height (5 total instead of 4) plus the 50mm.  🖇️Assembly: It is pretty straightforward, connect the dovetail (GLUE IS HIGHLY RECOMMENDED) and stack 4-100mm plus 1-50mm and finally the top part.  Spool holders can be added after or while stacking the tower. Just make sure to check for spool clearance.  You can find the PTFE tube funnel