X-Wing Maneuver dial with recessed text

**WIP**

I wanted a version of the maneuver dials that I could fill with acrylic or crayon. I also wanted to fix the problem where the insides of characters like 4 or A were lost on the top of the dial due to nothing holding them in place.

Cut depth is configurable, currently set to .8mm, via the variable cut_depth. This is still a bit buggy, so other properties may need editing.

Until I figure out what is going on, print all 3 parts separately, otherwise none of the names come through.

This is best printed vertically, rather than the dials flat on the build plate. The text looks a lot cleaner, and does not require support, though the "touching buildplate" is needed for the pin and protrusions.

Post-processing will involve a lot of sanding. If you have bad z-wobble, increase cut depth so you can sand away more material and not lose the cavity for filling with color..