X-Y Hole & Contour Test

IntroductionCalibration Guide: Using This Model to Adjust X-Y Hole and X-Y Contour Compensation.1. Initial PrintFor your first test, print the model using the printer's default settings without any adjustments.2. Measure DimensionsUse a caliper to measure the following two dimensions:X-Y contour compensationThe ideal measurement should be approximately 75mm x 35mm.X-Y hole compensationThe diameter error should be consistently minimal across all holes.Elephant foot (over-extrusion at the bottom layer) may cause measurement errors. To minimize this, perform multiple measurements and measure from the top surface of the model using the caliper.Always enable Precise Z height, as it is a critical setting to ensure vertical accuracy during printing.3. Calculate Compensation ValuesDivide the observed error by 2 and input the results into the X-Y hole compensation and X-Y contour compensation settings.If you can estimate the Elephant foot error during repeated measurements, you can include