Thingiverse
X1 Drag Chain
by Nyles
1
Downloads
1
Likes
0
Makes
Super annoying when the website wipes your summary and then complains about it.
This is the drag chain I use on my X1 printer to keep the bed cable from kinking.
1X ChainStrain00
18X DragChain00
Drilled a couple small holes in the case to run a tie-wrap, and each link gets a tie-wrap.
Double sided sticky foam tape in section where the mounting hole for ChainStrain00
is.
This is the drag chain I use on my X1 printer to keep the bed cable from kinking.
1X ChainStrain00
18X DragChain00
Drilled a couple small holes in the case to run a tie-wrap, and each link gets a tie-wrap.
Double sided sticky foam tape in section where the mounting hole for ChainStrain00
is.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!