X1 Simple LED Light bar

This is a simple LED light bar I use on my X1 C. This is designed to fit this aquarium lighthttps://www.amazon.com/SEAOURA-Submersible-Adjustable-Brightness-12-23inch/dp/B0CJ2TCGMT/ref=sr_1_43?keywords=aquarium%2Blight%2B12%2Binch&sr=8-43&th=1Please be sure to order the 11 inch version of the lightNo gluing or screws requiredIf you print this standing on edge it prints well without any supports I used a gray PETG and it matches the printer really well. .2mm layer height15% infill I run the light at about ½ power. If I turn it up all the way the camera washed out because it is so bright.Gives good lighting to the entire print chamberFits well between an AMS and the lid handle on an X1Angled light for better chamber illuminationPrints in just over 2 - ½ hoursEntire project can be printed and assembled in under 3 hoursNo tools required, just snap the 2 pieces together and slide the light in from the right hand side. This is a snug fit so that there is no light bleed on either side. If the