X1C FanDuct 360

I was remix https://makerworld.com/en/models/599997#profileId-522100 this fan duct with little bit better for printing and add some extras. No need supports for printing, all come off easy. Also optimise connecting pegs prints separately, after need glue inside, much stronger. Need 4x2mm and 2x2mm magnets. I was testing lot of possible fan ducts of here, also from cults, must of no better how original or is poor design and can't conecting with front cover, have gaps or not working at all with X1C becomes of lidar is on the way. I will not say, my is the best solution, but for me finally works better.