X1C Plastic Ejection Chute

I could have simply obtained one of these from the internet, but I had some unique space constraints and a specific size of 10 mm magnets on hand, so I devised this solution. It takes four 10 mm x 2.5 mm magnets. The magent holes are set to a nominal size of 10.15 mm. I think a person could get by with just a press fit ,but I opted to use super glue as a redundancy. It seems to work well enough as far as I can tell, but if you should decide to make this yourself, make sure you don't cheap out on magnets. The ones that I'm using barely have enough pull to hold.