X1C Ultra Slim LED Riser

I don't like the look of LED risers. So I wanted one that was as minimal and unintrusive as possible.Unfortunately, the smallest one I could find was 20mm in height. So I made this one, at only 8mm in height! Uses this LED strip and connects directly to the LED pins on the X1C AP board and replaces your existing LED bar. Follow the photos to understand how to put the LED strip into the base print and how to fold the LED strip around the corners. It's very easy to print in only 2 plates, but because of how small it is, supports are required. You can then fill it around with foam to put your glass lid on it, but I instead chose to print 2 plates of a TPU gasket, which is included in the profile. No glue is required to put this together, but I chose to seal the TPU gasket to the base print using clear silicon sealant. You can find other models I have released for the X1C/AMS here:https://makerworld.com/en/u/2811301167/collections/109412