X1Carbon QuinLED Dig-Uno Controller Case

This is a case for the QuinLED Dig-Uno designed to be installed on the back of an X1 Carbon. It might work on the X1E and the P1S if they have the same bolt locations on the back, I don't have those models to test, but if someone tests and it works, let me know! This is intended to be used with any lid riser that allows you to install LED strips for additional lighting inside the print chamber. I designed this to use heat-set inserts. Are they overkill for this? Yep! Did I do it anyway because I had them on hand and I enjoy using them? Yep!Bill of Materials:8x M2 heat set inserts (I used Ruthex brand ones, but the CNCKitchen ones should work as well, most brands should be close enough to work)8x M2x6mm machine screws2x M3x8mm machine screws (these are for mounting the case to the printer)A DC barrel jack appropriate for your power supply. The mounting hole is 11mm in diameter. I used These From Amazon but anything that fits your power supply and fits in an 11mm hole should work fin