Thingiverse
X2 ELF 88 mini kit
door Joza
1
Downloads
0
Likes
0
Makes
18650 battery holder
I am using a DYI 18650 (LG HG2) with spot welded nickel strips and soldered XT30 lead.
The battery strap is an iFlight 10mm strap shortened by about 10mm.
Supports are required if printing in default orientation.
Landing feet
I modified the bottom plate of the frame to acommodate a whoop 1s FC with a bottom facing USB. These feet raise the quad 10mm from the ground. They also fasten with only two 6mm M2 screws (I am using nylon).
I printed a set of 5 at a time, laying them flat on the mounting face, no supports required.
I am using a DYI 18650 (LG HG2) with spot welded nickel strips and soldered XT30 lead.
The battery strap is an iFlight 10mm strap shortened by about 10mm.
Supports are required if printing in default orientation.
Landing feet
I modified the bottom plate of the frame to acommodate a whoop 1s FC with a bottom facing USB. These feet raise the quad 10mm from the ground. They also fasten with only two 6mm M2 screws (I am using nylon).
I printed a set of 5 at a time, laying them flat on the mounting face, no supports required.
Joza publiceert ook op
34 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!