X5S Dial Indicator Mount

Made this to set the z screws at the same height.

You will need a 1/4-20 X 1" screw and nut, or the metric equivalent (has to be 11mm across the flats of the hex nut).

Directions, remove fan shroud with fan, install nutPlate behind fan instead of original nuts, reinstall fan shroud, take out upper LH and lower RH fan screws, pull the nut into indicatorBracket with the screw, install indicatorBracket in the 2 fan screw holes, home the printer, install indicator and away you go.

What I found was my bed was already very close but the wheels on the extruder carriage runout .010" (0.254mm), another thing I have to correct on this thing!!!