Xbox Controller Stand with Swappable Logos

TLDRXbox one controller stand with improvements:-smoothed model-with customisable (multicolour) decorations-low printing time-5x2 mm magnets and 8x3 mm anti slip rubber pads optional Why I made this remixI found a great controller stand design by agepbiz but I wanted to make it more personal.First off, I found a ‘smoothed’ version of the model (remix) that looked better as a starting material.Next up, I imported some SVG's with fallout logo's and added them to the controller. However, printing time increased from 1.5 to 8 hours and filament use was almost doubled, with half of it being wasted in flushing volume (image below)! I thought I could do better. So I used Fusion360 to carefully create a rectangular and circular cutout, that I could print flat on the bed to reduce the amount of filament swaps considerably.It did fit very well and followed the contour of the original design. Unfortunately, it didn't look very nice as stair stepping was quite visible. I'm excited