Xbox Logo 3D

Three versions
1. Separate parts, print separately and hot melt glue together
2. Elevated X
3. Depressed X

Please post makes, especially 2 color.

Printed on Ender 3S1, Gnvtntp Tri-Color Coextrusion Silk Red-Green-Blue Filament and Geeetech Silk silver.


I played with seam hiding in Cura, see below for recommended settings at least for my Ender 3S1. I recommend going through each seam option and doing a preview with 'starts' checked to see where each layer begins, it's the white dots. Play with the seam settings until most of the 'starts' are on an edge or corner. Smart hiding was one of the worst options, many starts were in a smooth area, go figure.


Recommended settings for all:
Top/Bottom Pattern: concentric
layer height: .12mm
adaptive layers


RECOMMENDED SEAM HIDING SETTINGS FOR EACH VERSION so most of the starts are on an edge:
Settings for XBOX_Depressed_X and XBOX_Elevated_X
z seam alignment: sharpest corner
seam corner preference: expose seam


Settings for XBOX_Outside_