Thingiverse
Gadgets
Go to Model
Xbox One Controller & Headset Holder - Extra Support
262
Downloads
190
Likes
6
Makes
V2: 23/12/2021
Made headphone holder thicker so item can be printed on its side, meaning the controller holding part is much stronger. Still no supports needed
V1:
The original model this was made from felt a little weak on the controller section, and could fail after prolonged use with a heavier controller. I have added a 45° angle support to fix this issue.
Made headphone holder thicker so item can be printed on its side, meaning the controller holding part is much stronger. Still no supports needed
V1:
The original model this was made from felt a little weak on the controller section, and could fail after prolonged use with a heavier controller. I have added a 45° angle support to fix this issue.
Gary_BBGames also publishes on
25 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
