Thingiverse
Gadgets
Go to Model
Xbox Series X Risers
341
Downloads
289
Likes
1
Makes
Just a simple set of risers for the Xbox Series X.
For fear of it getting scuffed, I just designed these real quick to lift it up about
15mm. I printed in TPU but if you use something like PLA, I would suggest gluing foam or something soft to them to keep from leaving marks on the console.
I added a center piece for support, but in my opinion it's not necessary.
Also added a version that is just a single corner foot. Print 4 of them.
For fear of it getting scuffed, I just designed these real quick to lift it up about
15mm. I printed in TPU but if you use something like PLA, I would suggest gluing foam or something soft to them to keep from leaving marks on the console.
I added a center piece for support, but in my opinion it's not necessary.
Also added a version that is just a single corner foot. Print 4 of them.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
