Thingiverse
Xbox Wireless Receiver Holder
by Rapidhearts
11
Downloads
5
Likes
0
Makes
Made this Xbox Wireless receiver holder for my pc as I was sick of it
falling off my desk and losing it.
I put a clip at the front for the usb plug so it was easy to find after
using the usb port for other things. The gap for the clip to hold it
to the desk is 17 mm.
It takes about an hour and 6 minutes to print with 20% infill, 2 shells and a raft. Supports are needed for the desk clip.
falling off my desk and losing it.
I put a clip at the front for the usb plug so it was easy to find after
using the usb port for other things. The gap for the clip to hold it
to the desk is 17 mm.
It takes about an hour and 6 minutes to print with 20% infill, 2 shells and a raft. Supports are needed for the desk clip.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
