XL Bauble

by ENIQUE3D · Home & Decor

0 Downloads

0 Likes

0 Makes

The XL Bauble. Approx 10", 25cm if printed on the H2S. you can scale up or down. The top is threaded and prints separately, then just screws into place. Ive Printed in Ziro, green silk. I cannot stress enough, You must have good adhesion or use a brim. If using Silk, With All silks it's not suitable for supertack or similar cool plate. As silk is significantly weaker than normal PLA and break when removing. The inside does require supports but the supports created when using Tree auto are quite decorative and could be used as a decoration on their own. Ive set top z to 0.275 which has always worked well for me. otherwise its, 0.2 layer, infill is irrelevant as it just prints walls. so leave at 15%. Lastly as i know i will get asked, i will release a plain version soon. and Drop below any suggestions for alternate text.